Kenmore 580. 72089 User Manual download pdf (Page 8)

_ FRONT INSTALLATION

Install the front grille(packed separately) onto the

cabinet as follows:

• Hook upper tabs of front grille into slots on the

cabinet top° (FIG, 19)

o Push front gritle's tips towards the cabinet in order

to snap side tabs into the cabinet, (FIG,,19)

• Open the inlet grille.,(FIG, 20)

• installthe screw (ITEM E) through the front grille.

(FIGo20)

oCtese inlet grille. (FIG.,21)

Front lnstaflation

FIG, 19

Front Installation _.t

Front installation FIG. 21

_IF AIR CONDITIONER IS BLOCKED BY

STORM WINDOW FRAME

, If storm windowpresents interference, fasten a 2'*

wide wood strip to the inner window sill across the full

width of the sill The wood strip should be thick

enough to raise the heightof the window silt so that

the unit can be installedwithout interference fromthe

the storm window frame. See FfG 22

Top of wood strip should be approximately 3/4"

higher than the storm window frame to help

condensation to drain properly to the outside

• Install a second wood strip (approximately 6" long by

1V2"wide and same thicknessas first strip) inthe

center of the outer sill flush against the back of the

inner sill Screw the L brackets into thisstrip

This will raise the L bracket as shown in F1G 22,

1 1/2" min

WOOD STRIP MOUNTED (38ram)

ON TOP OF INNER S_LL __ --_- 3/4"

CLEARANCE V

_L,

J" ] 4 _ _ WINDOW

INNER ]L BRACKET I FRAME

J J OUTER

l I S LL

INSIDE 1 OUTSIDE

FIG, 22

REMOVAL FROM WINDOW

• Turn off and unplugtheair conditioner

. Remove thefrontgrille,SeeHOWTO REMOVETHE

FRONTGRILLE Referto page 13

. Unscrewthe sidescrewsthatyou installedinStep 15

• Slidethe air conditionerout efthecabinet,

BE CAREFULNOTTO DROPIT, Held onto it firmly the

whole way slidingit out Once removed,set it safety out

of theway

- Remove theL bracketfromwindowframeand the sash

seal from betweenthe windows

• Unscrewthe sidecurtainsfromthe windowframe Fold

thembackto thesides of the cabinet

=Remove screwsattachingcabinetto inner sill Be careful

not te tot cabinetfall once screwsareremoved

• Removecabinetfrom windowopening,

• Place air conditionerinto cabinet Reinstallside screws

and Front Grille

• Place unit and all assemblyhardwarein air conditioner

shippingcarton, and storeinclean,dry place

° Air conditioners covered in this manual pose an

excessive weight hazard. Two or more people

are needed to move and install the unit.

To prevent injury or strain, use proper lifting and

carrying techniques when moving unit

• When handling the air conditioner, be careful to

avoid cuts from sharp metal fins on front and

rear coils,,

• Make sure air conditioner does not fall during

removal.

-8-

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Comments to this Manuals

No comments

Kenmore 580. 72089 User Manual Page 8

Comments to this Manuals