Kenmore Room 70089 User Manual download pdf (Page 9)

Installation

Figure 6. Modifying Mobile Home Window

1. Indoor sash (shown open)

2. Wood strip (1½" wide)

3. Window sill

4. Window frame

Installation Procedure

1. See Figure 7. Raise indoor sash and measure sash

width, including portion in window track. Cut window

sill gasket (installation Kit Item A) to length of indoor

sash and apply to rear of indoor window sill.To

apply gasket, peel back about 2" of paper covedng

gasket adhesive, and carefully press exposed

adhesive to one end of window sill. Slowly peel away

remaining paper cover from gasket adhesive, and

press gasket to sill as paper is pulled away.

If window has been modified for installed storm

window, apply gasket to wood strip added to sill.

For mobile home installation, apply gasket to

outdoor side of window frame bottom lip.

Figure 7. Applying Window Sill Gasket

1. Indoor sash

2. Indoor sill

3. Paper covering gasket adhesive

4. Gasket

2. See Figure 8. Thread adjusting foot (Item B) through

bottom of support bracket (Item C). Measure width

of window and mark center point of outside sill.

Figure 8. Support Bracket Assembly

1. Support bracket

2. Adjusting foot

3. See Figure 9. Center supportbracket on outside sill,

1_/16"from rear edge of indoor sill. Secure bracket to

outdoor sill with 2 hex-head screws (Item D),

Figure 9. Installing Support Bracket

1. 13/16"gap

2. Center of window

3. Hex-head screws

4. Bubblelevel

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

No comments

Kenmore Room 70089 User Manual Page 9