Kenmore 15408 Owner's Manual download pdf (Page 9)

9

NOTE: During this time the room humidity

level will continue to be monitored and the

humidifier will cycle the fan on and off until

the filter is completely dry. The fan will

shut off leaving you with a dry humidifier

that is less prone to mold and mildew

growth. If DRY OUT MODE is not desired,

refill the humidifier with water and the fan

will return to the set speed.

NOTE: Fan automatically switches to

lowest speed during DRY OUT MODE.

Check Filter Indicator

The ability of any humidifier to efficiently

supply humidity output relies heavily on

the condition of the filter. As the filter

loads with impurities it gradually loses its

wicking capability. When this happens,

moisture output is reduced and the

humidifier has to work longer to satisfy the

selected setting. This humidifier has a

check filter reminder timed to appear after

720 hours of operation. When the display

shows an alternating “CF” and “room

humidity” setting at 5 second intervals it is

a reminder to check the filter condition.

NOTE: Some areas have high water

mineral content causing the need for more

frequent filter changes.

Refer to “Replacement and Care of Filter”

on page 10. If a build-up of deposits or

severe discoloration is evident replace the

filter to restore maximum efficiency.

®

Check Filter

Display

Quiet Comfort

Humidistat

The humidistat located on the power cord

senses the percentage of humidity in the

air. It causes the humidifier to cycle on

and off to maintain the selected humidity

SET point. The fan will turn on if the

“ROOM” reading falls 3% below the SET

point and will continue to run the

humidifier until a reading of 1% above the

SET point is achieved. The fan will turn off

until the ROOM reading falls 3% below

the SET point again.

Control Lock Out

To avoid unwanted tampering with the

humidifier settings the controls can be

locked.

Activation Procedure

After the humidifier functions have been

set up, hold the power button down for 5

seconds. The display will show “CL” for 2

seconds; release the power button and

the control will resume the display of the

room humidity. The room humidifier will

continue to function with the locked in

settings. If buttons are operated while

“CL” is active, the “CL” is displayed and

settings are unaffected.

Deactivation Procedure

To deactivate the “CL” function simply

press and hold the power button for 5

seconds. “CL” will flash at the rate of 1

second on and 1 second off for a period of

2 seconds and then resume the display of

room humidity.

Quiet Comfort

NOTE: Be sure humidistat is located

approximately 2 inches outside humidifier

body and power cord is free from

obstruction and away from any hot air

register.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Comments to this Manuals

No comments