Kenmore 790.4056 User Manual download pdf (Page 9)

Setting Surface Controls

Operating the Dual Surface Radiant Element

The cooktop is equipped with a dual radiant surface

element located at the right front (See Figures 1 & 2)

positions. “Single” and “Multi” on the control knob area

are used to indicate which coil of the dual radiant

element will heat. “Single” indicates that only the inner

coil will heat (Figure 3). “Multi” indicates that both inner

and outer coils will heat (Figure 4). You may switch

between settings at any time during cooking.

Figu.re 1

Figu.re 2

To Operate the Dual Surface Element

1. Place correctly sized cookware on the dual surface element.

Push in and turn the control knob as shown in Figure 3 for smaller

cookware orin Figure 4 for larger cookware.

Turn the knob to adjust the setting if needed. Start most cooking

operations on a higher setting and then turn to a lower setting to finish

cooking. Each surface element provides a constant amount of heat at

each setting. A glowing red surface heating area extending beyond

the bottom edge of the cookware indicates the cookware is too small

for the surface heating area.

When cooking has completed, turn the surface control knob to

OFF before removing the cookware. Note: The HE message will

appear in the display after turning the control knob to OFF if the cooktop is

still hot and remain on until the heating surface area has cooled

sufficiently. The message may remain on even though the controls are

turned OFF.

Note: See Table on previous page for recommended control settings.

‘-'0

»Hi

/1-

Figure 3

Single Setting

Figure 4

Dual Setting

Dual Radiant heating areas on ceramic

smooth top (shown in black)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Kenmore 790.4056 User Manual Page 9