Kenmore 417.8413 User Manual download pdf (Page 18)

Solutions to Common Problems

Avoid Service Checklist

Before calling for service, review this list. It may save both time and expense. The list includes common occurrences that

are not the result of defective workmanship or materials in this dryer.

IMPORTANT

Disconnect dryer from electrical service before performing any work on unit or on associated

systems (including electrical supply, gas inlet, water inlet or exhaust venting).

OCCURRENCE POSSIBLE CAUSE SOLUTION

Dryer does not start. Electrical power cord is not securely plugged in or

plug may be loose.

Make sure the plug fits tightly in wall outlet.

House fuse blown or circuit breaker tripped. Reset circuit breaker or replace fuse.

Make sure electrical line is not overloaded and the dryer is on a

separate circuit.

Thermal limiter tripped. Call Sears or another qualified service dealer for replacement.

Dryer runs but won’t

heat.

There are 2 house fuses in the dryer circuit. If 1 of the 2

fuses is blown, the drum may turn but the heater will not

operate (electric models).

Replace fuse.

Gas supply valve is not open (gas models). Check to make sure supply valve is open. See INSTALLATION

INSTRUCTIONS for procedure.

Dryer does not have enough air supply to support the

burner flame (gas models).

See INSTALLATION INSTRUCTIONS.

LP gas supply tank is empty or there has been a utility

interruption of natural gas (gas models).

Refill or replace tank.

Dryer should heat when utility service is restored.

Drying cycle takes too

long, outside of the

Lint filter is clogged with lint. Make sure all lint has been removed from the dryer lint filter

before starting each cycle.

dryer feels too hot or

smells hot.

Exhaust duct requirements have not been met. Exhaust duct must be at least 4 inches in diameter and made of

rigid or semi-rigid metal.

When in place, the duct must have no more than four 90°

bends and must not exceed length listed in INSTALLATION

INSTRUCTIONS.

Electric dryer is connected to a 208 volt circuit. Drying time will be 20% longer than drying on a 240 volt

circuit.

Drying procedures have not been followed. See "Operating Instructions.”

Outside exhaust hood or exhaust duct may be

clogged or restricted.

Clean out any obstruction.

High humidity. Use a dehumidifier near the dryer.

Drying cycle stops after

only a few minutes,

leaving load wet

Check Exhaust alerts have been overlooked and the

dryer shuts down after a few minutes.

Immediately inspect your venting system and make any repairs

or perform any cleaning procedures necessary.

Excessive wrinkling. Dryer is overloaded. Do not overload. See "Operating Instructions.”

Items left in dryer too long. Remove items as soon as cycle ends.

Insufficient sorting of items. See "Operating Instructions.”

Drying temperature too high. Follow fabric care label instructions.

Scratching or chipping

of the drum finish.

Foreign objects such as coins, pins, clips or buttons are

inside the dryer.*

Always remove foreign objects from pockets before laundering.

Remove objects from drum and restart dryer.

Permanently attached items such as belt buckles,

zippers and fasteners may be hitting the inside of the

drum.*

It may be necessary to sew a scrap of material securely around

ornaments before drying to prevent scratching and damage to

the dryer.

*Drum damage caused by foreign objects or permanently attached items is not covered by the warranty.

1 2 ... 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Kenmore 417.8413 User Manual Page 18

Comments to this Manuals

Related products and manuals for Dryers Kenmore 417.8413