Kenmore 30'' Updraft Range Hood 5261 Installation Guide download pdf (Page 9)

Rotate baffle. Reinsert baffle into air chute (as shown)

so that baffle tabs fit all the way into slots in air chute.

An audible "click" wiII be heard when fully instalIed. This

wil! close off the air flow through the non-ducted slots on

top of hood.

10. Re-install air chute, re-connect wire harness, and

replace light panel.

NOTE: Be careful not to trap wires between support fin

and light panel.

SLOTS

TABS

SUPPORT FiN

11. Remove appropriate Duct Knockout sf_s}from top or back

of hood.

TOP RECTANGULAR

DUCT KNOCKOUT

(Remove for 3¼" x 10"

Vertical & for 7" Round

Discharge)

SEMI-CIRCULAR

DUCT KNOCKOUT

(Remove for 7" Round

Discharge)

REAR

RECTANGULAR

DUCT KNOCKOUT

(Remove for 3¼" x 10"

Horizontal Discharge)

12.31_ '' x 10" Ducted Discharge OnBy:

Attach Damper/Duct Connector over knockout opening.

Make sure damper Pivot is nearest to Top/Back Edg_ of

hood. Remove _ from damper flap.

13.7" Round Ducted Discharge Onmy:

Re-install 7" Round Duct PBate removed in Step #1 under

"PREPARE THE HOOD" section. Install a 7" round damper

(purchase separately). Damper flap must open freely in

direction of air flow (away from range hood).

UP TO 1"

SIDE-TO-SDE

ADJUSTMENT

TAPE

TOP/BACK

EDGE

To accomodate off-center ductwork, the Damper/Duct

Connector can be installed up to 1-inch on either side of

hood center or the 7" Round Duct PBate can be installed up

to 1/2"on either side of hood center. In extreme off-center

installations, one end of the duct connector may need to

be trimmed to cmearthe emectrica{ cabmec_amp.

PIVOT

,'Vertical d_scharge

uos_tlon ShOWn)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comments to this Manuals

No comments

Kenmore 30'' Updraft Range Hood 5261 Installation Guide Page 9

Comments to this Manuals

Related products and manuals for Cooker hoods Kenmore 30'' Updraft Range Hood 5261