Kenmore 5751 User Manual download pdf (Page 3)

Location

Selecting a Location

IMPORTAi^T:

1- Dehumidifier must be operated in an enclosed area to be most effective

Close all doors, windows, and other outside openings to the room>

2- Rear of dehumidifier must be placed at least 8" from a wall or other

obstruction so as not to restrict airfiow to the coils or out of the front grili

3 A dehumidifier operating in a basement will have little or no effect in drying

an adjacent enclosed storage area, such as a closet, unless there is adequate

circulation of air in and out of the area It may be necessary to install a second

dehumidifler in the enclosed area for satisfactory drying

How it Works

Operating Steps

Dehumidifier Features

Fan Control Humidistat Control

\ I /

/T\

1 AUTOMATIC

. SHUTOFF

When the unit is started, the fan begins to pull moisture-laden air across the

dehumidifying coils. The coiis condense or draw moisture from the air, and air

flows through the front grili into the room as dry, warm air Moisture removed

from air is collected In a bucket on the back of the dehumidifier.

To begin operating the dehumidifier, follow these stepsi

1. Plug the power cord into a property grounded 110/120 volt outlet.

Note: Before operating this unit, see the "Removing Collected Water" section

for proper placement of the bucket Models will not operate if the bucket is

not properly positioned on the support posts.

2- When first using the dehumidifier, turn Humidistat Control clockwise

to the MAX. DRY position. The unit wili run continuously at this setting

Note: The dehumidifier should be kept in operation as long as excess moisture

is present in the room air

3 Turn the Fan Control to NORMAL. The NORMAL setting is recommended for

faster moisture removal.

4, Allow the dehumidifier to operate at the above settings for three to four days

After this time, adjust the controls as needed See below

Humidistat Control

The Humidistat Control automaticaily starts dehumidifier when humidity is

excessive. When humidity has been reduced to the comfort level set on the

control, the unit turns off

When first using dehumidifier, turn Humidistat Control ciockwise to MAX,. DRY,

and the Fan Control to NORMAL. Unit will run continuously at this setting

Operate dehumidifier at the MAX, DRY setting for three to four days. During this

time, observe the dampness conditions in the area being dried. When the

dampness and dampness odors are gone, adjust Humidistat Control to the

position between OFF and MAX, DRY that provides a "dryness" condition suitable

to your comfort needs

Fan Control (some models)

The Fan Control adjusts fan speed Turn Fan Control to NORMAL for maximum

moisture removal When humidity has been reduced to the desired levei and

quiet operation is preferred, set Fan Control to QUIET,

Wloisture Removal

At first, the dehumidifier will remove large amounts of moisture It will continue

to do so until the relative humidity is reduced to a point where moisture damage

will not occur- Then, the amount of moisture removed from the air will be a lot

less. This indicates the dehumidifier is operating effectively and Is maintaining the

relative humidity at the desired level Judge the performance of the dehumidifier

by the elimination of dampness and dampness odors, not by the amount of water

being deposited in the bucket When bucket has filled with water, unit will turn

off This model features an Automatic Shut-Off light that will glow until bucket is

emptied and returned to the proper position

1 2 3 4 5 6 7 8 9

Comments to this Manuals

No comments

Kenmore 5751 User Manual Page 3

Comments to this Manuals

Related products and manuals for Air equipment Kenmore 5751