Kenmore 251.90701 User Manual download pdf (Page 6)

ERROR CODES WIRELESS REMOTE MONITORING STATION

Error

Code

Error Type

Temperature

Sensor

Defrost

Sensor

Humidity

Sensor

Pump Drain

Possible Causes

1. Sudden change

in the

surrounding

temperature.

2. Faulty sensor.

. Improper

bucket

installation.

. Blockage to

drain hose

system.

. Back flow of

water through

pump drain

hose.

. Improper pump

drain hose

installation.

. Faulty drain

pump.

Corrective Actions

1. Unplug the dehumidifier.

2. Check the surrounding area for possible

reasons for sudden temperature changes.

3. Wait 30 minutes before plugging the

dehumidifier back in and resuming normal

operation.

4. If the “Error” is still indicated, please

contact your nearest service center.

1. Unplug the dehumidifier.

2. Remove the bucket.

3. Check to make sure that there is nothing

blocking the connection at the base of the

pump or the bucket.

4. Reinstall the bucket, taking care that it is

installed properly.

5. Check to make sure that the pump drain

hose is not crimped or blocked.

6. Check to make sure that the pump drain

hose is not both under water and sitting at

a height above the dehumidifier - this can

cause a “back flow” of water from the hose

to the dehumidifier.

7. Remove and reinstall the pump drain hose,

taking care that the pump drain hose is

installed properly.

8. Plug the dehumidifier in and restart

9. If the “E3” error is still indicated, please

contact your nearest service center.

The remote monitoring station is a receiver

with a receiving range of only 330 feet in

open air with no obstructions. Actual receiving

range will vary depending on what is in

the path of the signal transmitted from the

dehumidifier unit. Each obstruction (roof,

walls, floors, ceilings, thick trees, etc.) will

effectively cut signal range in half.

Example: The wireless remote monitor with

a 330-foot range is mounted on an interior

wall or placed on a countertop so the signal

from the dehumidifier has to pass through one

basement wall, across the 10-foot width of the

room through the room’s other wall and then

through the floor to the room upstairs where

the receiver is located. The first wall

will reduce the range to 165 feet, and the

second wall will reduce the range to 87 feet.

Factoring in the 10-foot room, this leaves

a maximum of 77 feet of remaining signal

range. Passing up through the floor has now

reduced the effective range to 38 feet.

Typically this allowance is enough for most

frame-constructed homes; however certain

materials can reduce range even further.

Metal siding, stucco, and some types of

glass can reduce signal range by as much

as 75% compared to the 50% reduction

typical of most obstructions. It is possible

to receive a signal through these materials;

however maximum range will be much less,

due to their tendency to absorb or reflect

a much larger portion of the dehumidifier’s

signal.

NOTE: You may have to move the monitor

closer to the main unit if it is not receiving a

proper signal following set-up procedures.

PRODUCT SPECIFICATIONS

Classification

Spec

Remark

Model 251.90701

Power Supply AC 115V/60(Hz)

Moisture Removal 70 Pint(33.1 liters) 24-Hour Period

Control Type Electronic

Refrigerant R410A/11.29 oz. 320g

Humidity

Display

Humidity Setting: 35%-70%

Display Range: 20%-90%

5% Increments

1% Increments. Current Humidity.

Temperature

Display

Display Range: Lo, 36-99°F, Hi 1° F Increments. Current Temp.

Display Range: Lo, 2-37°C, Hi 1° C Increments. Current Temp.

Timed Shut-off Setting Range: 1Hr-12Hr 1 Hour Increments

Fan Motor Speed 3 Speeds Auto/High/Low

Dimensions 15.74x25.59x13.6 in 400x650x346mm

Net Weight 49 lbs 22.3Kg

Operating Temp. 36^-99^

Drain Pump 12V DC

Pump Drain Hose .25 in X 18 ft 6.35x5,486mm

Setup Guide

Insert the batteries in the monitor. After

the batteries are inserted, the Monitoring

Station will start receiving signal data from

the dehumidifier: temperature, humidity, etc.

should be displayed on the monitor’s screen.

If this doesn't happen after 2 minutes, check

the dehumidifier to make sure it is operating

properly. Remove the batteries from the

monitor, wait a minute, then replace.

Batteries

iiBi <

OS: 00

111

Oj^

TEMPEi?ATUi?E

ijrf

(jn

(3 Receiver On

Battery Strength

Sound Aiert

Time of Day

Fan On

O Bucket Fuii

O Pump On

O Temperature

O Humidity

O Waii Hanger

O Set Button

(3 Minus

QPIus

O Sound On/Off

10 11

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

Comments to this Manuals

No comments

Kenmore 251.90701 User Manual Page 6

Comments to this Manuals

Related products and manuals for Air equipment Kenmore 251.90701