Kenmore 58650 User Manual download pdf (Page 20)

Never use this water heater unless it is completely full of water.

To prevent damage to the tank and heating element, the tank

must be ﬁ lled with water. Water must ﬂ ow from the hot water

faucet before turning “ON” power.

14. Check element for water leaks. If leakage occurs, tighten

element or repeat steps 2 and 3, remove element and

reposition gasket. Then repeat steps 10 through 14.

15. Reconnect the two wires to the element and then check to

make sure the thermostat remains ﬁ rmly against the surface

of the tank.

FIGURE 27.

16. Replace terminal cover on thermostat making sure that the

locking tabs on the terminal cover are in place.

FIGURE 28.

17. Replace the insulation so that it completely covers the

thermostat and element.

FIGURE 29.

18. Replace access panel.

19. Turn “ON” electric power to water heater.

FIGURE 30.

Drain Valve Washer Replacement

NOTE: For replacement, use a 17/32” x 13/64” x 1/8” thick

washer available at your nearest hardware store. For

ordering a replacement washer, refer to the Repair Parts

List section.

• Before beginning turn “OFF” the electrical power supply to

the water heater.

• Follow Draining instructions. See Draining section.

• Turning counter clockwise, remove the hex cap below the

screw handle.

• Remove the washer and put the new one in place.

• Screw the handle and cap assembly back into the drain valve

and retighten using a wrench. DO NOT OVER TIGHTEN.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

No comments

Kenmore 58650 User Manual Page 20