Kenmore 7146611 User Manual download pdf (Page 10)

SECTION 3

PUT THE AUTOMATIC IRON FILTER TOGETER

3A. ASSEMBLE FEEDER VALVE AND BOTTLE. CONNECT TO MINERAL TANK

IF INSTALLING A CLARIFIER, NEUTRALIZER OR TASTE

&ODOR FILTER, SKIP THIS PAGE AND GOTO PAGE 11.

1. At the location you have chosen to install the filter, lift

and set the mineral tank assembly onto the larger end of

the base (Figure 3).

CAUTION: BE CAREFUL WHEN YOU LIFT THE TANK,

AS IT IS HEAVY. DO NOT LIFT BY THE VALVE OR VALVE

COVERS.

2. Check the feeder valve to be sure the large o-ring

seal is in place on the underside. Then remove the cap

from the bottle and carefully turn the valve into the bottle.

After the o-ring just touches the top of the bottle, tighten

another 1/8 turn. DO NOT OVERTIGHTEN OR THE

BOTTLE WILL DEFORM AND LEAK.

WARNING: HANDLE THE BOTTLE CAREFULLY. THE

POWDER (POTASSIUM PERMANGANATE) IN THE

BOTTLE STAINS DEEPLY. KEEP IT AWAY FROM CHIL

DREN.

NOTE: The bottle is only partly filled with powder (about

6 lbs.). The empty part of the bottle is needed so it can

fill with water to dissolve the powder.

3. Shake the bottle to level the powder. Then set the

bottle and feeder valve assembly into the base, next to

the mineral tank (Figure 3). You can turn the base ro the

bottle is on either side of the tank.

4. Remove the filter top cover (held in place with four

screws).

5. Take the 4 ft. length of 5/16” O.D. plastic tubing and

connect it to the feeder valve, and to the nozzle venturi

housing on the filter (Figure 4). Tighten the nut-ferrules

as tight as you can with your fingers.

6. Carefully replace the top cover, aligning with the face

plate, and install the four screws.

FIG. 3

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

No comments

Kenmore 7146611 User Manual Page 10