Kenmore 91382 Owner's Manual download pdf (Page 8)

INSTALLATION INSTRUCTIONS

KEY DIMENSIONS AND SPECIFICATIONS

LOCATION REQUIREMENTS

IMPORTANT: Read all installation instructions

completely before installing and operating your dryer.

It is important that you review this entire manual before

installing and using your dryer. It contains detailed

instructions concerning electrical connections, gas

connections and exhaust requirements.

CHOOSE THE PROPER LOCATION

• Store and install the dryer where it will not be exposed

to temperatures below freezing or exposed to outdoor

weather conditions.

• Choose a location with a solid, level ﬂ oor.

• If the dryer is being installed in a garage, place the

dryer at least 18 inches (45.7cm) above the ﬂ oor.

• Properly ground the dryer to conform with all

governing codes and ordinances.

• To reduce the risk of electric shock, do not install the

dryer in damp or wet locations.

NOTE: Installing the dryer in a humid space, or installing or

storing the dryer where it will be exposed to the weather or

freezing temperatures, may result in rust or other dam-

age that is not covered by the product warranty.

IMPORTANT: If you are installing your dryer in a

manufactured or mobile home, please refer to the

Special Electrical Requirements for Mobile or

Manufactured Homes section.

CLEARANCES

• Most installations require a minimum 5 inch (12.7 cm)

clearance behind the dryer for the exhaust ducting.

• Allow minimum clearances of at least 1 inch (2.5 cm)

on the sides and back to minimize vibration and noise.

• Allowing additional clearance for installation and

servicing is recommended.

• Be sure to allow for wall, door, or ﬂ oor moldings that

may increase the required clearances.

• Allow at least 22 ½ inches (57.3 cm) in front of the

dryer to open the door.

Additional instructions for closet installations:

The closet door must allow for suﬃ cient airﬂ ow. Refer to the

diagram above for minimum vent opening requirements. A

louvered door is also acceptable.

Description Dryer (Gas and Electric)

Electrical Requirements Refer to the rating label

Gas Requirements* NG: 4–10.5 inches WC (Water Column)

Gas Requirements* LP: 8–13 inches WC

Dimensions 27 in. (W) X 30

1/4

in. (D) X 38

in. (H), 51

in. (D with door open)

68.6 cm (W) X 76.7 cm (D) X 98.3 cm (H), 130 cm (D with door open)

Net Weight Electric : 133.6 lb. (60.6 kg) Gas : 137.6 lb. (62.4 kg)

Drying Capacity IEC 7.4 cu. ft.

*Gas Models Only

22 1/2 in.

(57.3 cm)

30 1/4 in.

(76.7 cm)

5 in.

(12.7 cm)

5 in.

(12.7 cm)

51 3/16 in.

(130 cm)

1 in.

(2.5 cm)

1 in.

(2.5 cm)

27 in.

(68.6 cm)

48 sq. in.

(310 sq. cm.)

24 sq. in.

(155 sq. cm.

)

(7.6 cm)

Vent

Standard Installation – Side View

Standard Installation – Front View

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Comments to this Manuals

No comments

Kenmore 91382 Owner's Manual Page 8

Comments to this Manuals

Related products and manuals for Tumble dryers Kenmore 91382