7
6
OPERATING INSTRUCTIONS
Always operate the heater in the upright position following all instructions and
recommendations listed in this manual.
HEATER LOCATION
Place the heater in the area of the room that is coldest.
HEATER CONNECTION
outlet. A loose connection may cause overheating and damage to the plug or heater.
NOTE: To prevent overloading a circuit, do not plug the heater into a circuit that is
servicing other electrical needs.
HEATER OPERATION
TURNING HEATER ON
OPERATING INSTRUCTIONS
To start the heater, turn the from the OFF position to
the LOW or HIGH setting.
During the heaters initial use, you may experience a slight odor or
smoking. This is the result of the heating element lubrication
POWER LIGHTS
This heater is with a Power
The light will
when the is in to
alert that the has
Fig. 2
This heater has two heat the higher setting to
raise the room temperature quickly. When the desired temperature is reached use the
Low is to maintain a The
will run at a higher speed when used at the high 1500 watt setting the
750 watt low setting. When used at the high 1500 watt or watt setting, both
quartz tubes will heat up and illuminate. The will more when
at the watt settings the watt low
POWER CONTROL DIAL
After heater has been turned on and the area has reached the desired temperature,
rotate the Thermostat Control the heater
hear a the thermostat at this setting the heater
will automatically maintain this temperature. To maintain a lower
rotate the control to the To maintain a higher
rotate the control to the
SETTING THERMOSTAT
CARE AND MAINTENANCE
The power indicator light, located near the control panel, lights whenever the heater or
fan is turned on. The heater is equipped with an automatic overheat protection device
located inside the body of the heater. If the heater grill is obstructed, or if the heater
gets too hot for any reason, the automatic overheat protection device will turn
The heater is also
the heater when the heater tips over. To resume heater functions simply stand heater
upright.
IMPORTANT SAFETY FEATURES
before unplugging or
plugging in the heater. Heater should be unplugged when not in use.
TURNING OFF
DO NOT USE HEATER IF EITHER QUARTZ TUBE IS CRACKED OR BROKEN.
QUARTZ TUBES
WARNING:
REPAIR
Do not attempt to open the heater to clean or otherwise service the inside. If the heater
does not function normally, call the following customer assistance number to arrange
for possible heater service and repair:
Keep original carton for storage of the heater. Coil and tie the power cord to avoid
damage during storage.
Before cleaning the heater be sure to disconnect power cord and allow
the heater to cool completely.
CLEANING
CAUTION:
CAUTION:
Do not operate the heater without the grill in place. Do not use the
heater if it has malfunctioned or become damaged in any way.
STORAGE
Kenmore
Themostat
(9 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals