Kenmore 790.7050 User Manual download pdf (Page 19)

Before You Call • Solutions to common problems

Problem Solution

Oven smokes excessively during

broiling.

Incorrect setting. Follow broil instructions in Setting Oven Controls.

Broiler drawer is open. Be sure broiler drawer is closed.

Meat too close to broil burner. Reposition the broiler drawer rack to

provide proper clearance between the meat & the burner.

Meat not properly prepared. Remove excess fat from meat. Cut remaining

fatty edges to prevent curling, but do not cut into lean.

Broiler pan and insert wrong side up and grease not draining. Always place

insert on the broiler pan with ribs up & slots down to allow grease to drip

into pan.

Grease built up on drawer surfaces. Regular cleaning is necessary when

broiling frequently. Old grease or food spatters cause excessive smoking.

Flames inside oven or smoking from oven

vent.

Excessive spillovers in oven. For example this will happen for pie spillovers

or large amounts of grease left on the oven bottom. Wipe up excessive

spillovers before starting oven. If flames or excessive smoke are present

see

Broil in Setting Oven Controls section.

Oven control panel beeps & displays any

F code error.

• Oven control has detected a fault or error condition. Press stop; to clear

the error code. Try the Bake or Broil feature again. If the F code error

repeats, remove power from appliance, wait 5 minutes and then repower

appliance and set clock for the time of day. Try the Bake or Broil feature

again. If the fault recurs, press the stop key pad to clear.

Call 1-800-4-MY-HOME® for assistance (See back cover).

Appliance is not level.

Be sure floor is level, strong & stable enough to adequately support range.

If floor is sagging or sloping, contact a carpenter to correct the situation.

Poor installation. Place oven rack in center of oven. Place a level on the

oven rack. Adjust leveling legs at base of appliance until the rack is level.

Kitchen cabinet alignment may make range appear not level. Be sure

cabinets are square & have sufficient room for appliance clearance.

Cannot move appliance easily.

Appliance must be accessible for

service.

Oven control beeps and displays F code

• Cabinets not square or are built in too tightly. Contact builder or installer to

make appliance accessible.

• Carpet interferes with appliance. Provide sufficient space so appliance can

be lifted over carpet.

• Gas line is hard-plumbed. Have a flexible CSA International approved

metal appliance connector installed.

• Oven control has detected a fault or error condition. Press stop key pad to

clear the error code. Try Bake or Broil function. If the F code error repeats,

remove power from appliance, wait 5 minutes and then repower appliance

and set clock with the correct time of day. Try Bake or Broil function again.

If the fault recurs, press stop to clear and call 1-800-4-MY-HOME® for

assistance (See back cover).

1 2 ... 14 15 16 17 18 19 20 21 22

Comments to this Manuals

No comments

Kenmore 790.7050 User Manual Page 19

Comments to this Manuals

Related products and manuals for Radio Kenmore 790.7050