Kenmore 77106 Owner's Manual download pdf (Page 14)

TROUBLESHOOTING

Page 14

If problems not listed in the table occur or recommended solutions do not work, contact a

qualiﬁed service dealer for repair. Do not disassemble the air conditioner. Unqualiﬁed

repair will void the warranty, and may cause injury to users or damage to property.

Problems Reasons Solutions

The air

conditioner

does not work.

The cooling eﬀect

is not good

Loud Noise

Compressor does

not work.

The remote control

does not work.

Display reads E1

Display reads E2

There is no electricity.

The overﬂow indicator displays FL.

The ambient temperature is too low or

too high

In cooling mode, the room

temperature is lower than the set

temperature

In dehumidiﬁcation mode, the ambient

temperature is low.

There is direct sunlight.

Doors or windows are open; there are a

lot of people in the room; or in cooling

mode, there are other sources of heat.

The ﬁlter screen is dirty.

The air inlet or outlet is blocked.

The air conditioner is not placed on a

ﬂat surface.

Overheat protection is active.

The distance between the unit and the

remote control is too far.

The remote control is not aligned with

the direction of the remote control

receiver.

Batteries are dead.

The coil temperature sensor is

malfunctioning.

The room temperature sensor is

malfunctioning.

Turn unit on after connecting it to a

socket with electricity.

Discharge the water inside.

Run the unit within the ambient

temperature range of 44-95 ˚F

(7-35˚C).

Change the set temperature.

Place the unit in a room with an

ambient temperature of greater than

62 ˚F (17 ˚C).

Pull the room curtain closed.

Close doors and windows, and add

new air conditioner.

Clean or replace the ﬁlter screen.

Clear obstructions.

Put the air conditioner on a ﬂat and

hard place (to reduce noise).

Wait for 3 minutes until unit cools, then

restart.

Move the remote control closer to the

air conditioner, and make sure that the

remote control directly faces in the

direction of the remote control receiver

on the unit.

Replace batteries.

Call for service.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 29 30

Comments to this Manuals

No comments

Kenmore 77106 Owner's Manual Page 14

Comments to this Manuals

Related products and manuals for Mobile air conditioners Kenmore 77106