Kenmore 77063 Owner's Manual download pdf (Page 8)

ADDITIONAL THINGS YOU SHOULD KNOW

EXHAUST CONTROL :

This Exhaust Control allows the air conditioner to either recirculate inside air (CLOSED) or exhaust air to the outside

(OPEN).

The CLOSED position is used when maximum cooling is desired. It may also be used for air recirculation without

cooling when the air conditioner is set in any FAN position.

The OPEN position removes stale air from the room and exhausts it to the outside. Fresh air is drawn in through normal

passages in the home.

4-WAY LOUVERS

AUTO RE-START :

After a power outage, the unit will remember the last temperature and mode settings, and will return to these same settings

once power is restored.

Air directional louvers control air flow direction. Your air

conditioner has the 4-way directional system described below.

The louvers will allow you to direct the air flow Up or Down

and Left or Right throughout the room as needed. Use the

central handle to adjust the air directional louvers side-to-side

until the desired Left or Right direction is obtained. Pivot

horizontal louvers with your fingertips until the desired

Up/Down direction is obtained. There are a total of 4 possible

air directional orientations available with this system.

Now that you understand the basic operation functions, here are more control features with which you should become

familiar.

The “cool” circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. This prevents

overheating of the compressor and possible circuit breaker tripping. The fan will continue to run during this time.

The control will maintain the set temperature within 2 degrees Fahrenheit, between 60F and 90F degrees.

There is a 2-Second delay for the compressor shutting down when selecting FAN ONLY. This is to cover the possibility

of having to roll through to select another mode.

When the unit is turned off in cool or energy saver mode, it will run in energy saver mode when it is turned on again, but

the setting of temperature and fan speed will remain.

If the unit is turned off in heat mode (if applicable) or fan only mode, it will return to the same setting when it is turned

on again.

The control is capable of displaying temperature in degrees Fahrenheit or degrees Celsius. To convert from one to the

other and back, press and hold both the “TEMP/TIMER” Up( ) and Down ( ) buttons for 3 seconds.

FAULT CODES :

If the display reads “ES” or “AS”, a sensor has failed. Contact 1-844-553-6667 for repair.

Evaporator coil sensor Air temperature sensor

Models with a key hole overflow drain hole can use drain kit 5304481680 to connect a 1/2 inch drain hose for safe

disposal of excess system water. This part can be ordered at www.SearsPartsDirect.com.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Kenmore 77063 Owner's Manual Page 8