Kenmore 790.4885 User Manual download pdf (Page 31)

Before You Cali

Solutions to Common Problems

Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that

are not the result of defective workmanship or materials in this appliance.

OCCURRENCE POSSIBLE CAUSE/SOLUTION

Microwave Oven

Control pads for Sensor Cooking,

One-Touch Cooking, and Defrost

will not operate.

The oven door was opened and closed without initiating a cooking cycle

within three minutes. Touch Stop/Clear to resume normal pad operation.

Microwave oven light does not If one of those situation appear please check the electrical outlet, fuse

come on. Cooling fan does not

work. Turntable does not rotate.

and/or circuit breaker. If they are functioning properly, contact Sears Part

& Repair. A microwave oven should never be servicer by a “do-it-yourself”

repair person.

Water in a cup in microwave does

If this situation appears please check the electrical outlet, fuse and/or circuit

not warm.

breaker. If they are functioning properly, contact Sears Part & Repair. A

microwave oven should never be servicer by a “do-it-yourself” repair person.

Time appearing in the display is

counting down very rapidly.

Please check Demonstration Mode on page 15 and cancel.

Lower Oven

Wall Oven Control Beeps and Electronic control has detected a fault condition. Press STOP to clear the

Displays any F code error (example

F11).

display and stop the beeping. Reprogram the oven. If a fault reoccurs, record

the fault number. Press STOP and call Sears or another qualified servicer.

-dr- is displayed. The door was left open and controls set for self-cleaning cycle. Close the

door and push STOP pad.

Installation. Place oven rack in center of oven. Place a level on the oven rack. Contact

installing agent if rack and cabinet cutout flooring are not level.

Kitchen cabinet misalignment may make oven appear to be not level.

Be sure cabinets are square and level. Contact cabinet maker to correct

problem.

Entire Wall oven does not operate. When the oven is first plugged in, or when the power supply to the oven has

been interrupted, the display will flash. The oven cannot be programmed until

the clock is set.

Be sure electrical cord is securely connected into the electrical junction box.

Cord/plug is not installed and/or connected. Cord is not supplied with oven.

Contact Sears or another qualified servicer.

Service wiring not complete. Contact Sears or another qualified servicer.

Power outage. Check house lights to be sure. Call your local electric

company.

Short in cord/plug. Replace cord/plug.

Controls are not set properly. See instructions under Setting Oven Controls

to set the controls.

House fuse has blown or circuit breaker has tripped immediately following

installation. House fuse may not be fully engaged. Check fuse and screw or

engage circuit breaker securely.

House fuse has blown or circuit breaker has tripped after the oven has been

installed and previously operating. Call Sears or another qualified servicer.

Fan noise during cooking operation. A cooling fan may automatically turn on and off to cool internal parts. This is

normal, and the fan may continue to run even after oven is turned off.

Wall oven light does not work.

Burned-out or loose bulb. Follow the instructions under Changing Oven

Light to replace or tighten the bulb.

1 2 ... 26 27 28 29 30 31 32 33 34

Comments to this Manuals

No comments

Kenmore 790.4885 User Manual Page 31

Comments to this Manuals

Related products and manuals for Microwaves Kenmore 790.4885