Kenmore 25328452805 User Manual download pdf (Page 5)

FIRST STEPS

This Use & Care Guide provides specific operating

instructions for your model. Use the freezer only as

instructed in this Use & Care Guide. Before starting the

freezer, follow these important first steps.

INSTALLATION

• Choose a place that is near a grounded eiectricai

outiet. Do Not use an extension cord or an adapter

plug.

• For the most efficient operation, the freezer should

be located where surrounding temperatures will not

exceed 110“F (43“C). Temperatures of 32°F (0°C) and

below will NOT affect freezer operation. Additional

compressor heaters are not recommended.

• Allow space around the unit for good air circulation.

Leave a 3 inch (75 mm) space on all sides of the

freezer for adequate circulation.

Crating

Screw

Discard The (4) Crating Screws

And (2) Wood Bases

Unpacking and Leveling -- Upright Models

NOTE: The exterior walls of the freezer may become quite

warm as the compressor works to transfer heat from the

inside. Temperatures as much as 30° F warmer than room

temperature can be expected. For this reason it is particu

larly important in hotter climates to allow enough space for

air circulation around your freezer.

LEVELING

The freezer must have all bottom corners resting firmly on

a solid floor. The floor must be strong enough to support

a fully loaded freezer. NOTE: It is VERY IMPORTANT tor

your freezer to be level in order to function properly. If the

freezer is not leveled during installation, the door may be

misaligned and not close or seal properly, causing cooling,

frost, or moisture problems.

To Level Upright Models:

After discarding crating screws and wood base, use a car

penter’s level to level the freezer from front-to-back. Adjust

the plastic leveling feet in front, bubble higher, so that

the door closes easily when left halfway open.

To Level Chest Models:

If needed, add metal or wood shims between foot pads

and floor.

CLEANING (PRIORTO USE)

• Wash any removable parts, the freezer interior, and

exterior with mild detergent and warm water. Wipe dry.

Do not use harsh cleaners on these surfaces.

* Do not use razor blades or other sharp instruments,

which can scratch the appliance surface when

removing adhesive labels. Any glue left from the tape

can be removed with a mixture of warm water and mild

detergent, or touch the residue with the sticky side

of tape already removed. Do not remove the serial

plate.

■

1 2 3 4 5 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments

Kenmore 25328452805 User Manual Page 5

Comments to this Manuals

Related products and manuals for Freezers Kenmore 25328452805