Kenmore 51392 Owner's Manual download pdf (Page 9)

DUCTED INSTALLATIONS ONLY

7. Remove 3¼” x 10” vertical, 3¼” x 10” horizontal, or 7-inch round knockout plate as appropriate for your ducting

method (see FIGURES 1 A and 1 B).

NOTE: To accommodate oﬀ -center ductwork, the 7” round duct plate can be installed up to 1/2” on either side of

the hood center.

7” ROUND

DUCT

PLATE

SCREWS

FIGURE 3

3¼” X 10”

DAMPER

ASSEMBLY

SCREWS

FIGURE 2 A

TOP/BACK

EDGE OF

HOOD

DAMPER

FLAP

PIVOT

FIGURE 2 B

3¼” X 10”

DAMPER

ASSEMBLY

BACK OF

HOOD

DAMPER

FLAP

PIVOT

SCREWS

7” ROUND

KNOCKOUT PLATE

(ALSO REMOVE VERTICAL

KNOCKOUT PLATE)

3¼” X 10”

VERTICAL

KNOCKOUT

PLATE

3¼” X 10”

HORIZONTAL

KNOCKOUT

PLATE

FIGURE 1 A FIGURE 1 B

8. Attach 3¼” x 10” Damper Assembly on top OR back of hood (if using 3¼” x 10” duct; shaded part in F

IGURE 2 A)

or 7” Round Duct Plate (if using 7-inch round duct, FIGURE 3) over the knockout opening. When installed, the 3¼” x

10” damper assembly must open as shown in F

IGURE 2 B.

TIP: Insert a small length of duct over the 3¼” x 10” damper assembly (for rectangular ducting) or 7” round (for round

ducting) and seal the joint using aluminum foil duct tape to ease connection with the house ductwork.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Comments to this Manuals

No comments

Kenmore 51392 Owner's Manual Page 9

Comments to this Manuals

Related products and manuals for Cooker hoods Kenmore 51392